Beer Making
Spare parts for beer barrels
-
Hambleton Bard Barrel Inlet only Valve
£6.99More information
A brass gas inlet only valve. As this has no built in pressure relief, do make sure that your barrel is fitted with an alternative safety valve.
-
Hambleton Bard Cap 4'' O Ring
£1.85 More information -
Hambleton Bard Inlet and Relief Valve Complete
£6.99More information
This brass unit combines the two functions of gas inlet valve and of pressure relief.
The external thread at the top fits the internal thread on either Hambleton Bard S20 or S30 gas cylinders to allow gas to be injected into a barrel.
A relief valve is fitted under the brass collar which helps prevent over pressurisation. -
Hambleton Bard Inlet and Relief Valve Seal - Brown
40pMore information
This relief valve seal fits both the Weltonhurst Brass Barrel Valve and the Hambleton Bard Inlet and Relief valve.
-
Hambleton Bard Inlet Sealing Sleeve - Purple
50pMore information
Originally Purple but quickly fading to clear this sleeve fits on the inlet pin of Hambleton Bard Combined Inlet and Relief Valve.
-
Hambleton Bard Inlet Valve Rubbers - Orange
50p More information -
Hambleton Bard Relief Valve
£4.75 More information -
Hambleton Bard Relief Valve Rubber - Yellow
50p More information -
Hambleton Bard S30 gas cylinder - new
£21.50More information
This is the most commonly used CO2 cylinder for topping up the pressure in home beer barrels. It can be used with each of the beer barrels shown on our website provided that it is fitted with a gas injection valve rather than a simple vent cap.
Just screw the cylinder down onto the valve to start the gas flowing and turn it back it again to stop.
The gas should be added to the keg in short bursts of 1 second to stop the cylinder freezing in the open position. Running the end of the cylinder under hot water prior to use will also help to prevent this.
These cylinders contain 245g of compressed Carbon Dioxide.
These cylinders are an economical way of adding CO2 to your beer. -
Hambleton Bard S30 gas cylinder - refill
£4.60More information
This is the most commonly used refillable CO2 cylinder for topping up the pressure in home beer barrels. It can be used with each of the beer barrels shown on our website provided that it is fitted with a gas injection valve rather than a simple vent cap.
Just screw the cylinder down onto the valve to start the gas flowing and turn it back it again to stop.
The gas should be added to the keg in short bursts of 1 second to stop the cylinder freezing in the open position.
Running the end of the cylinder under hot water after use will also help to prevent this.
These cylinders contain 245g of compressed Carbon Dioxide.
Please note that as this item is a refill we will need to receive an empty cylinder from you before we dispatch your order.




