Beer Making
Mash tuns, Boilers, Aerators, Hop strainers, Pumps, Chillers, Grain mills, Burners and Steel Fermenters.
-
Brupaks Boiler
£140.00
This is a substantially constructed with composite material, thermostatically controlled boiler.
It comes with a stainless steel ball valve tap which is fitted with a stainless steel mesh hop strainer.
Stable, robust & made for the job.
It is rated at 2000W and has a capacity of 29 litres.
The overall height is 46cm and the maximum diameter is 40cm.
You may also require...
-
Immersion Wort Chiller
£55.00More detail and information
When you have successfully achieved the hot break the wort clears as proteins coagulate, fall out of solution and become visible as trub.
If the wort is allowed to cool slowly these proteins go back into solution and the wort will go cloudy.
If however it is chilled quickly a further large quantity of trub is formed and the wort will remain clear.
This is called the cold break.
Using this chiller a good cold break can be achieved, the time taken to complete the brewing process is reduced, and the yeast can be pitched in earlier to shorten the dangerous lag period before fermentation starts.
The Immersion Wort Cooler comes with both inlet and outlet tubing for the water.
These are quality clear braided thick walled polythene, each 1.25m long with an ID of 10mm and an OD of 16mm.
These will push fit onto the inlet and outlet of the copper tubing (you may want to secure them with jubilee type clips (not supplied)) and the water outlet runs free.
The water inlet end will need to be secured to a tap with a suitable connector depending on the tap used to supply it. -
Mash Tun - standard
£69.95More detail and information
With a capacity of 32 litres this holds a full 10kg of grain which is enough to make a minimum of 10 gallons of beer. It is fitted with an integral copper wort separator.
-
Counterflow Wort Cooler - Stainless Steel Plate Type
£95.00More detail and information
The fastest cooler we have.
Homebrew version of a professional plate heat exchanger with 12 stainless steel plates .
No pump required (gravity feed is sufficient). Cools 20 litres of hot wort to 20°C in under 10 minutes!!!
It is supplied complete with 4 3/4" BSP pipe fittings to take 13mm (1/2") tubing. -
Mash Tun - superior
£115.00More detail and information
This Insulated 45 litre Mash Tun holds up to 15kg of grain.
It is fitted with a 22cm diameter domed stainless steel false bottom which is connected to the steel ball valve tap with a screw in barbed end which means that this can be used for both mashing and sparging.
Recessed lifting handles are moulded into the blue lower section whilst swing lever handles are fitted higher up.
It's dimensions are 48cm deep including the tap, 44cm wide and 44cm tall.
It's not cheap but the best rarely is! -
Braided Tubing - 10mm internal diameter
£2.25More detail and information
A 1 metre length of thick walled nylon braided syphon PVC tubing with an 10mm bore reinforced with nylon mesh and suitable for use with liquids up to 100°C.
Tightness of fit is eased by dipping the end in hot water.
If you order 2 units of this item you will receive one 2- metre length in one piece, 3 units as a 3 metre length etc.
