Beer Making
Mash tuns, Boilers, Aerators, Hop strainers, Pumps, Chillers, Grain mills, Burners and Steel Fermenters.
-
De Luxe Mash Tun - superior
£115.00
This Insulated 45 litre Mash Tun holds up to 15kg of grain.
It is fitted with a 22cm diameter domed stainless steel false bottom which is connected to the steel ball valve tap with a screw in barbed end which means that this can be used for both mashing and sparging.
Recessed lifting handles are moulded into the blue lower section whilst swing lever handles are fitted higher up.
It's dimensions are 48cm deep including the tap, 44cm wide and 44cm tall.
To obtain the best results preheat the tun well to strike temperature or slightly above with the lid on.
Make the initial mash temperature 5C above normal prior to adding the grist then seal the tun for the entire mash length unchecked.
It's not cheap but the best rarely is!
You may also require...
-
Mash Thermometer
£13.95More detail and information
An alcohol filled thermometer within a protective casing.
It has a maximum overall length of 28.5cm and a range of -10 to +110 degrees C. -
Rotating Sparge Arm
£24.95More detail and information
This is a self-powered rotating sparge arm which produces a fine evenly distributed spray enabling an efficient sparge to be easily achieved.
With one end of the supplied clear tubing attached to the top of the sparge arm simply attach the other end to your hot liquor tank (a suitable connector will be required).
The flat white support plate (95mm by 390mm) sits on top of your boiler / lauter tun with the rotating arm suspended below.
Note, if using with the mash tun superior a simple longer support plate will be necessary.
A movable O ring on the shaft enables the height of the arm to be adjusted to a suitable vertical position.
As the liquor runs through the arm this rotates providing a fine spray over your mash.
The vertical shaft is 200mm long .The rotating arm is 290mm but it can be trimmed if necessary.
Note if using with the Mash Tun Superior, the support arm is too short & needs to be either extended slightly or substituted with another longer sealed support arm with an aperture for the upright spigot of the rotating arm. -
Wort Boiling Pan - 32 litre
£62.00More detail and information
A restaurant grade stainless steel boiling pan complete with a 1/2" bore stainless steel ball valve tap with stainless steel mesh filter.
Cheapest boiler around, needs independent heat source.
Suitable for use with a gas burner/range/non induction hob......
Only put on the tap tubing after the heating source has been extinguished.
Diameter 35cm, Maximum overall height 37cm.
Weight:2.75Kg -
Braided Tubing - 12.5mm internal diameter
£2.50More detail and information
A 1 metre length of thick walled nylon food grade braided syphon PVC tubing with an 12.5mm bore reinforced with nylon mesh and suitable for use in temperatures of up to 70C.
Tightness of fit is eased by dipping the end in hot water.
If you order 2 units of this item you will receive one 2- metre length in one piece, 3 units as a 3 metre length etc. -
Big Button Timer
£10.00More detail and information
A big button 99 minute timer perfect for infusion, stepped and decoction mashes as well as for the boil.
It has a large start/stop button, counts either up or down, and has a good beeper with adequate volume. Magnets on the back can hold it in place but it has a one piece fold out stand as well.
It frees the brewer to focus on other aspects of brewing without having to watch the clock!
